Y-Cables Set John Deere set 2 advanced for 6R series

Y-Cables Set John Deere set 2 advanced for 6R series

John Deere set 2 advanced for 6R series, complete set with 28 Y-cables plus 18 pin plastic breakout box, 574210018.

Of Y-cable or splitter cable is placed between the sensor/actuator and harness connector to allow the sensor to function normally in a working engine management system. By connecting the 18 pin breakout box to this cable, a measurement of the signals to and from the sensor can be performed in a safe and reliable way. This can be done by using a multimeter or scope. The pin assignment with the pin numbers on the connector is equal to the number of numbers on the breakout box. In this way it is no longer necessary to prick in cables to measure a signal. The use of a paper clip and measuring along the seals is therefore a thing of the past. This way there is no hole in the insulation of the wire or the seal and the copper of the wire cannot oxidize and cause problems in the future. It will also no longer be necessary to measure in a loose connector with the risk of damage to the contact. Moreover, the sensor no longer works with a loose connector!

See here here for an overview of all included connectors in format PDF.