Search
0
Shopping Cart
Choose!

Y-Cables Set Isuzu 4JJ1 Stage 3B-Tier 4 interim






Share:

Y-Cables Set Isuzu 4JJ1 Stage 3B-Tier 4 interim

Isuzu 4JJ1 Stage 3B-Tier 4 interim, complete set with 16 Y-cables plus 18 pin plastic breakout box.

A Y-cable or splitter cable is placed between the sensor/actuator and harness connector to allow the sensor to function normally in a working engine management system. By connecting the 18 pin breakout box to this cable, a measurement of the signals to and from the sensor can be performed in a safe and reliable way. This can be done by using a multimeter or scope. The pin assignment with the pin numbers on the connector is equal to the number of numbers on the breakout box. In this way it is no longer necessary to prick in cables to measure a signal. The use of a paper clip and measuring along the seals is therefore a thing of the past. This way there is no hole in the insulation of the wire or the seal and the copper of the wire cannot oxidize and cause problems in the future. It will also no longer be necessary to measure in a loose connector with the risk of damage to the contact. Moreover, the sensor no longer works with a loose connector!

574210018 18 Pin Breakout Box with Rubber Case
574300002 Storage case without inlay
575500010 Airmass meter
575600025 Inlet valve
575300031 Map sensor
575200021 575030032
575200000 Inlet temperature
575200004 MPROP and fuel injector
575200000 Turbo wastgate activator
575100000 EGR valve
575200060  
575300000 Oil pressure or level sensor
575100000 Airco pump clutch
575300035 DPF Differential
575300033 Fuel filter sensor
575200000 Low pressure fuel pomp
575200000 Generator
575200000 DPF inlet temp. Sensor
575200000 DPF inside temp. Sensor

Write a review

Note: HTML is not translated!
    Bad           Good

Do you have any questions about Y-Cables Set Isuzu 4JJ1 Stage 3B-Tier 4 interim?