Y-Cables Set Common Rail

Y-Cables Set Common Rail with Breakout Box Parallel

Common Rail set, complete set with 8 Y-cables and the 18 pin plastic breakout box plus storage case small.

This set consists of the most common connectors of the common rail system on all passenger cars. Please note, the case only contains Y-cables and no loose connectors.

Of Y-cable or splitter cable is placed between the sensor/actuator and harness connector to allow the sensor to function normally in a working engine management system. By connecting the 18 pin breakout box to this cable, a measurement of the signals to and from the sensor can be performed in a safe and reliable way. This can be done by using a multimeter or scope. The pin assignment with the pin numbers on the connector is equal to the number of numbers on the breakout box. In this way it is no longer necessary to prick in cables to measure a signal. The use of a paper clip and measuring along the seals is therefore a thing of the past. This way there is no hole in the insulation of the wire or the seal and the copper of the wire cannot oxidize and cause problems in the future. It will also no longer be necessary to measure in a loose connector with the risk of damage to the contact. Moreover, the sensor no longer works with a loose connector!